EZ-COOK ADAPTER

(ROUGH EDGES -- Handle Carefully!!)

1. Loosen the nuts on each side of the lantern hood (Part #123), just as you would, when changing a mantle.

2. Remove hood (part #123).

3. Place EZ-Cook adapter onto the top of the lantern, by lining up the two (2) slotted legs with the loosened nuts.

4. In some cases, you may have to bend the slotted legs out a tad bit to line them up, with the nuts.

5. Place hand on top of the EZ Cook, press down gently, and tighten the nuts securely.

6. Light the lantern, and YOU’RE COOKIN’!!

!! EZ-Cook Adapter also fits All 500CP & 350CP lanterns !!

Below Photos of bending Tabs If needed

Slotted legs fit nut side of frame (#121)

Below: how to install EZ Cook into the carrying case (Remove Top Burner Plate)

Top Burner Plate goes in with reflector (Top Reflector caes cover)