I saw on the page a video about how to adjust the needle so it comes up through the nipple.
Well, I did just that and now when I turn the shut off know to the 12 oclock position the lantern doesn't go out. It only goes down to a slow glimer. I have to let all the air out to extinguish my lantern.
Should I set the needle back like it was or do I need to install a new needle?
The slow glimer is sort of pleasant.

Hello,

This does not shut off the lantern it should run a few sec. or even min. it shuts off in the tank part 193 before you light the lantern, pump it up with pressure pull out part 117 then look at part 50 and see if fuel comes out with the needle sticking out, if yes then you need to replace part 90, 193, 194, and if there’s trash in part 195 then change it too.

If there’s no leak you do not have a problem you can adjust your needle as high or low as you like it just needs to come out of part 50.
Parts page: http://www.britelyt.com/lanternparts.htm

God Bless!!